A new product that will make your life easier when using your 3D printer
You have an Goliat extruder, Tytan3D (http://www.tytan3d.com/en) ?
This is a powerful extruder. Unfortunately, it is not easy to use...
You get into trouble to:
Clean your Goliat extruder.
Adjust the position of the drive gear MK7.
Press the lever arm (for the old version).
Disassemble the motor.
You often disassemble because:
It quickly clogs.
The filament twists around the drive gear MK7.
Thread does not fit into the guide holes.
To clean the drive gear MK7, you must remove the 4 screws holding the board linker gear.These parts are not always accessible.You have to twist your body to access it.This disassembly / assembly takes at least 6 minutes.
So you are concerned by these few essential accessories they'll make it life simple. Finally, they will allow you to quickly maintain your extruder. You will not think any more "I must..."
Thanks to the accessory "EasyFix", the motor will be disassembled / assembled in 15 seconds.
It replaces the board linker gear without changing the Goliat extruder.
The EasyFix is an adapter between Goliat and Nema17 motor with gearbox, Type: 17HS13-0404S-PG27.
The 17HS13-0404S-PG27 is the most suitable for pushing the filament, both for grip and speed force.
EasyFix, Motor and Goliat
EasyFix is mounted with 4 cylindric screws M3x25 and 2 cylindric screws M3x10 on the Goliat extruder.
EasyFix is an anodized aluminum plate (thickness 5 mm).It has the same external dimensions as the board linker gear.
Test EasyFix for free
You want to test EasyFix?
Download the .stl file and print it.